Macros

Each of the 32 knobs has four macros (rows 0–3). A macro maps knob motion to MIDI messages, rack device parameters, S32 LFOs, or CV16 outputs.

Configure from Perform → Press Select (short) Select (edit mode) → select macro row → Press Select (short) Select again to open the macro parameter grid.

Guides

Guide	What it covers
Setting up macros	Step-by-step walkthrough from Perform to a configured macro.
Text editor	Rename knobs, rigs, racks, and snapshots with the virtual keyboard.
SysEx editor	Edit SysEx bytes, MSB/LSB slots, and knob modulation targets.

Macro mode reference

Off

• Disabled(Disabled) — Macro produces no output.

Standard MIDI

• Control Change(CC) — Send 7-bit MIDI Control Change messages.
• Program Change(PC) — Send MIDI Program Change messages.
• 14-bit Control Change(CC14) — Send 14-bit MIDI Control Change (MSB + LSB pair).
• Channel Aftertouch(AT) — Send MIDI channel aftertouch (pressure).
• NRPN(NRPN) — Send Non-Registered Parameter Number messages.
• RPN(RPN) — Send Registered Parameter Number messages.
• SysEx(SysEx) — Send System Exclusive with knob-modulated payload bytes.

Internal routing

• MIDI Device Parameter(Device) — Modulate a rack device parameter inside the S32.
• S32 LFO Parameter(S32 LFO) — Modulate a global S32 LFO parameter.

CV16 expander

• CV16 Direct Control(CV16 Ctrl) — Output CV16 control voltage on a selected jack.
• CV16 LFO Parameter(CV16 LFO) — Modulate a CV16 expander LFO parameter.

Quick comparison

Category	Modes
Off	Disabled
Standard MIDI	CC, PC, CC14, AT, NRPN, RPN, SysEx
Internal routing	Device, S32 LFO
CV16 expander	CV16 Ctrl, CV16 LFO

Common fields

Most active modes include some of these rows:

Field	Meaning
Minimum / Maximum	Endpoints mapped to knob travel
Channel	MIDI channel (or Global)
Invert	Reverse knob direction
Outputs	USB / DIN port mask (MIDI modes)

Related topics

• Edit Mode — reaching macro grids
• Mapping — knob macros and external MIDI
• Modulation — LFO → device, LFO → LFO, LFO → macro
• LFOs — global modulation sources