Appearance
Controls
| Do this | To |
|---|---|
| Press Select (short) Press Select | Open what's highlighted, or edit a value |
| Press Back (short) Press Back | Go back one step |
| Hold Select (long press) Hold Select | Open the side menu |
| Hold Back and Select together Hold Select + Back | Open the Main Menu, or switch tabs |
| Press the encoder Press the encoder | Start or stop the clock |
The encoder press can open Racks or LFOs instead: ENCODER BUTTON.
Edit a value
- Press Select (short) Press Select on the value.
- Turn the encoder Turn the encoder. The change takes effect as you turn.
- Press Select (short) Press Select or Press Back (short) Back to finish. The new value stays.
For a quick change, Hold Select (long press) hold Select, turn, and let go.
- Turn slowly for single steps, faster to cover a wide range.
- ON/OFF settings work the same way: turn to ON or OFF.
- Values stop at their first and last setting; they don't wrap around.
- Action rows, such as RECORD or RANDOMIZE, act on a single press.
- A dimmed setting doesn't apply right now, such as KEY NOTE while the Envelope's TRIGGER isn't KEY. The encoder skips it and it keeps its value.
Side menus
Hold Select (long press) Hold Select on a row, card or pad to open its side menu, like right-clicking on a computer. It holds what you can do with that item: rename, duplicate, remove, Modulation, Mapping, IN SNAPSHOT.Press Select (short) Select picks a choice. Press Back (short) Back goes back one level, then closes the menu.On Perform, holding Select opens edit mode instead.
Dialogs
A dialog with two buttons asks before an action. Turn the encoder to choose one, then Press Select (short) Select. Press Back (short) Back always cancels, whichever button has the focus.


Confirmations that delete, clear or overwrite something start on BACK, so turn to the action to confirm.
Select + Back
Hold Back and Select together Hold Select + Back:- On Perform or the Knobs Grid: open the Main Menu.
- On a screen with tabs: switch tabs.
- Anywhere else: nothing.
Header marks
A small mark left of the BPM shows what the buttons do right now.
While a snapshot bank glides, the line under the header fills from left to right.

| Mark | Means |
|---|---|
| Two squares over a dashed line | Select + Back switches tabs here |
| Circle and square | Select is held: turning changes the value |
| Square filling up | Keep holding Select: the side menu (on Perform, edit mode) opens when it's full |
| Floppy | The project is saving |
| Warning triangle | A MIDI output was full and skipped some new notes. See When an output is full |
Related topics
- Hardware — Panel and rear connections
- Perform View — The screen you play from
- Edit mode — Macros, names and BPM on Perform