Appearance
S32 LFO Parameter
Sets a setting of one of the project's LFOs.

When to use it
Play an LFO: speed it up, deepen it, change its shape. The knob changes the LFO's own setting. SAVE PROJECT keeps it, and a morph back to 0% returns to it.
Settings
| Setting | Range | What it does |
|---|---|---|
| LFO INDEX | LFO 1 – 16 | The LFO the knob sets. |
| CV PARAM. | LFO setting | The setting the knob changes. See the table below. |
| MINIMUM / MAXIMUM | The setting's range | In the setting's own units: note values or Hz, %, degrees. |
Also INVERT and PICKUP: see Settings most modes share.
What the knob can set
Pick it with CV PARAM.:
| CV PARAM. | What it does |
|---|---|
| ENABLED | Turns the LFO on or off. |
| WAVETABLE | The wave shape. |
| RATE | How fast it runs: a note value with SYNC on, Hz with it off. |
| SYNC | Follows the clock, or runs free. |
| DEPTH | How far it moves its targets. |
| OFFSET | Shifts the whole wave up or down. |
| PHASE | Where in the wave it starts. |